ISUZU RING

Other Rings You Might Enjoy:

4x4 Extreme Off Road Ring First Gen S-10 Blazer Hummer WebRing 4x4 Recreation Offroad 4x4 WebRing Four Wheel Drive and SUV

It's been so long.... - Blimey, time flies, and house extensions seem to have taken most of it up. Anyway you may remember some months ago I talked about the handbrake being less than efficient. I thought as part of my quest to fix all the various oil leaks and little niggles, that I'd investigate further. Hmmm. On removing the drum I found a lot of oil. The rear output ... - 2009/07/14

Harrowing times - Well after many inches of snow, spring briefly arrived last weekend, and having emptied the trailer of the mower, in readyness for work to start on that, a quick journey to the next village resulted in the purchase of a good heavy secondhand set of harrows. Sunday was spent harrowing one of the paddocks, if the weather holds I'll be doing the rest... - 2009/02/26

PTO done - next project : the mower - Well I've finished the rebuild of the PTO, now just have to mount it on the land rover. Next project (and not a land rover!) is the mower, which will be towed by my series one and powered of the PTO More details and updates on the land rover it's self soon, but here is a picture of the mower and the PTO - 2009/02/04

almost no progress! - Hmm well, summers gone, winters here and nothing much has changed. Ah well, I'd like to have lots of excuses but in reality, things like having an extension built, and general chores have taken up some time, the rest is down to spending time in the workshop but not actually progressing much! However I'm now putting in place my cunning plan to make ... - 2008/11/05

Slow progress - Wel, as you can see by the long silence, I didn't get things done in time. Work and other things have intervened. A brief update, Repro master cylinder, worse than the original, so decided to refurbish the original (again) and have another go. Brakes now seem like they are coming back so a few more goes with the ezeibleed and hopefully that be that... - 2008/07/30

Short update on progress - A brief progress update. I've no bought a new (repro) master cylinder since my last attempts at changing the seals on the old one didn't fix the leak, so I can only conclude it needs a full refurb. I've fitted the reproduction one, now just the tedium of bleeding the system. I've taken some time off this week so expect more soon. as an aside, why a... - 2008/06/03